20
lippert.com 432-LIPPERT (432-547-7378) Rev: 08.29.22
Quick Drop Stabilizer
Installation and Owner’s Manual
(For Aftermarket Applications)
CCD-0004455
NOTE: It may take a few attempts of adjusting the Quick
Drop Leg and turning the hex coupler to achieve the
optimal stabilization (Fig. 38).
5. Repeat process for other stabilizer legs.
NOTE: Upon completion, the inner arm should not have
moved beyond a 90 degree angle; perpendicular to the
assembly body. Doing so may cause the mechanism to
bind and cause damage.
ONCE THE STABILIZER LEGS HAVE BEEN
EXTENDED, DO NOT USE THE TONGUE JACK ON
A TRAVEL TRAILER OR THE LANDING GEAR ON A
5TH WHEEL. DAMAGE TO THE STABILIZER LEGS
CAN OCCUR WHEN LIFTING OR LEVELING THE
TRAILER AFTER THE STABILIZER LEGS HAVE BEEN
EXTENDED. DOING SO WILL VOID THE WARRANTY
OF THE STABILIZERS.
Fig.38
Ground
Retracting Stabilizers
1. Using a ¾” socket on a ratchet or cordless drill, turn the
hex coupler (Fig. 37A) counterclockwise to begin raising the
foot pad o the ground.
NOTE: Use of an impact drill is not recommended and will
cause damage to the mechanism.
QUICK RETRACTING STABILIZERS CAN PINCH, CUT,
SCRATCH OR INJURE FINGERS AND HANDS.
KEEP CLEAR AND USE CAUTION WHEN OPERATING
STABILIZERS TO AVOID PERSONAL INJURY.
Fig.37
A
To Next Page
Loading...
