TME-104P-CSR-LX800-R1V5.doc Rev 1.5 27 (44)
Pin A B C D
1 GND Reserved +5 Volts AD00
2 VI/O AD02 AD01 +5 Volts
3 AD05 GND AD04 AD03
4 C/BE0 AD07 GND AD06
5 GND AD09 AD08 GND
6 AD11 VI/O AD10 M66EN
7 AD14 AD13 GND AD12
8 n.c. C/BE1 AD15 n.c.
9 SERR GND SB0 PAR
10 GND PERR n.c. SDONE
11 STOP n.c. LOCK GND
12 n.c. TRDY GND DEVSEL
13 FRAME GND IRDY n.c.
14 GND AD16 n.c. C/BE2
15 AD18 n.c. AD17 GND
16 AD21 AD20 GND AD19
17 n.c. AD23 AD22 n.c.
18 IDSEL0 GND IDSEL IDSEL2
19 AD24 C/BE3 VI/O IDSEL3
20 GND AD26 AD25 GND
21 AD29 +5 Volts AD28 AD27
22 +5 Volts AD30 GND AD31
23 REQ0 GND REQ1 VI/O
24 GND REQ2 +5 Volts GNT0
25 GNT1 VI/O GNT2 GND
26 +5 Volts CLK0 GND CKL1
27 CLK2 +5 Volts CLK3 GND
28 GND INTD +5 Volts RST
29 +12 Volts INTA INTB INTC
30 -12 Volts REQ3 GNT3 GND
Note: All VI/O pins are connected to +3.3V.
The voltages +5V and +12V are not generated by the onboard
power-supply but routed from the Power Supply Connector. This
board does not support -12 Volts. The maximum current is limited
to 1.0 amp for each voltage.
To Next Page
Loading...