TME-104P-CSR-LX800-R1V5.doc Rev 1.5 26 (44)
3.16 Reset-In Signal
The "Reset-In" signal is located on the IDC10 Header PS/2. To reset the board, the signal "Reset-In"
must be pulled to GND.
Connector type
IDC10 pin header 2.54 mm
Pin
Signal Pin
Signal
1 Speaker 2 Mouse Clock
3 Reset-In 4 Mouse Data
5 KB Data 6 KB Clock
7 GND 8 +5 Volt Standby
9 Ext. Battery 10 Power Button
3.17 PC/104-Plus Bus Interface
The PC/104-Plus bus is a modification of the standard PCI bus. It allows all of the PC/104 features to
be used, together with the high speed PCI bus.
The main features are:
• PC/104-Plus Bus slot, fully compatible with PCI version 2.2 specifications.
• Integrated PCI arbitration interface (32 bit wide, 3.3V).
• Translation of PCI cycles to ISA bus.
• Translation of ISA master initiated cycle to PCI.
• Support for burst read/write from PCI master.
• 33 MHz PCI clock.
Note: The 3.3 V pins on the PC/104 Plus bus are not supplied by the
onboard 3.3 V power supply. If a PC/104 Plus peripheral board is
used that needs 3.3V from the bus as power the customer must
supply this voltage by himself.
To Next Page
Loading...