TME-104P-CSR-LX800-R1V5.doc Rev 1.5 30 (44)
Field Selection
To move between fields in Setup, use the keys listed below:
Key Function
Æ, Å, È, Ç
Move between fields
+, - Selects next/previous values in fields
Enter Go to the submenu for the field
Esc To previous field then to exit menu
In order to save your settings, select Save values and Exit and confirm with Y.
Should you want to discard everything, select Exit Without Save.
When troubleshooting a system, it is highly recommend to first restoring the BIOS's factory settings
before any debugging is done. This is achieved with Load Defaults in the main setup menu. If you
cannot reach the BIOS setup, because of bad system configuration, reset the board five times for
loading default values.
The Motherboard Device Configurations menu allows configuring the drives, LPC, DDMA, display,
GPIO usage, and PCI configuration. The CPU's temperature can be read here, too.
To Next Page
Loading...