Lippert SureShade Power Bimini - Troubleshooting

Rev: 01.04.22 Page 10 CCD-0004321
Troubleshooting
What is Happening Why? What Should Be Done?
Top does not raise or
lower.
No power. Turn on boat's electrical power.
Bad electrical harness.
Contact Lippert.
Email: customerservice@lci1.com
Phone: 432-LIPPERT (432-547-7378)
Bad actuator.
Bad electrical
connection.
Check for loose or unconnected wires. Connect
wires.
Pinched/cut harness
wire.
Replace wire harness.
Bad controller.
Contact Lippert.
Email: customerservice@lci1.com
Phone: 432-LIPPERT (432-547-7378)
Controller power
indicator light not lit.
No electrical power. Turn on boat's electrical power.
Bad light. Replace controller.
Controller buttons do
not respond.
No electrical power. Turn on boat's electrical power.
Bad electrical
connection.
Check for loose or unconnected wires. Connect
wires.
Pinched/cut harness
wire.
Replace wire harness.
Bad controller.
Contact Lippert.
Email: customerservice@lci1.com
Phone: 432-LIPPERT (432-547-7378)
Mesh top sags.
Unzipped frame
pocket.
Zip all frame pockets closed
Unconnected snap(s). Connect all snaps.
Mesh top not fully
opened.
Fully open mesh top.
Fly extension stanchions
do not reach the locking
plates.
Fly extension not fully
extended.
Fully extend fly extension.
Bimini top not fully
extended.
Fully extend bimini top.
Locking plates
mounted too far away.
Relocate locking plates.
Stanchions do not lock
in-place.
Bad locking button.
Contact Lippert.
Email: customerservice@lci1.com
Phone: 432-LIPPERT (432-547-7378)
Tie-down strap does not
reach the saddle.
Saddle mounted too far
away.
Relocate saddle.
Tie-down strap not
extended enough.
Adjust tie-down strap buckle to increase strap
length.
Tie-down strap clip does
not close on saddle or
stanchion.
Bad spring clip. Replace tie-down strap.