Rev: 01.04.22 Page 8 CCD-0004321
II. Release the locking button.
D. Extend and clip each stanchion's tie-down strap (Fig. 5A) onto its respective saddle (Fig. 5B).
Fly Extension
Fig. 4
The optional Lippert front fly extension is only compatible with bimini tops equipped with a zippered front
storage pocket that accommodates the attachment and storage of the fly extension and stanchions. The
stanchions are equipped with adjustable tie-down straps.
1. If necessary, open the bimini top to its fully opened position.
NOTE: Do NOT fully open the QC bimini system without a top installed or failure of the system willresult.
2. Extend the fly extension towards the front of the boat as follows:
A. Unzip the front storage bimini pocket and unfurl the fly extension to release the stanchions.
B. Grasp the stanchions and walk the fly extension towards the front of the boat.
C. Insert each stanchion in its respective locking plate.
I. Slide the locking button (Fig. 4A) on a locking plate back then insert the stanchion pole's
swivel stud (Fig. 4B) into the locking plate.
Fig. 5
A
B
A
B
Do NOT exceed 15 mph when y extension is deployed. Exceeding maximum speed limit with y
extension deployed can cause damage to the extension and void product warranty.
To Next Page
Loading...
