Rev: 01.04.22 Page 5 CCD-0004321
Operation
Bimini Top
1. Turn on electrical power to the boat.
2. Remove any protective boot or restraints from the canvas or optional high speed mesh top.
3. To operate the quick-connect (QC) bimini top, use one of the following methods:
NOTE: Do NOT fully open the QC bimini system without a top installed or failure of the system will result.
A. If the bimini system is electrically connected to a helm switch, the top can be raised and lowered
by using:
I. The helm switch by pressing and holding the switch until the top is fully extended or
retracted and the actuators stop. Release the switch.
II. The QC controller buttons by pressing and holding the appropriate button (Fig. 1A) until the
top is fully extended or retracted and the actuators stop. Release the button.
Operation
Indicator Light
A
Fig. 1
To Next Page
Loading...
