Lippert SureShade Power Bimini - Manual Override

Rev: 01.04.22 Page 11 CCD-0004321
Manual Override
If the power bimini top will not retract into the radar or fully retracted position, a manual override of the
power bimini top must be done before putting the pontoon underway. Perform a manual override of the
power bimini top as follows:
1. If the fly extension is deployed, disconnect the fly extension stanchions and tie-down straps. Store the
fly extension in the top's front zippered storage pocket.
2. Unzip the front pocket of the bimini canvas. If available, have a second person push forward on the
rear frame to relieve some pressure off of the canvas then hold up the rear and middle frames when
the canvas is unzipped.
3. Place the rear frame and canvas in the down position (Fig. 7).
Fig. 7
4. Use the provided 5/32" hex wrench (Fig. 8A) to remove the two 1/4" hex cap screws (Fig. 8C) located at
the bottom of the front frame on both sides.
A. If the QC controller is not installed, a hex wrench will be located behind each actuator's end
cap(Fig. 8B)
B. If the QC controller is installed, a hex wrench will be located inside the front zippered
storagepocket of the top.
Fig. 8
Front Frame
Top Removed
from Front Frame
A
B
C
A