28
7.6 Oil change on the feed drive
Remove cover (Pos. 55)
Screw out the ventilation stopper (Pos. 56) from the feed
drive
Remove the drain screw (Pos. 63) under the joint cutter
Drain the oil and return the screw (Pos. 63)
Refill with 0.8l synthetic mineral oil CLP PG VG 220
(Aral = Degol GS 220, Esso = Glycollube 220,
Mobil = Glygoyle 30, Castrol = Alphasym PG 220)
Screw in the stopper (Pos. 56)
7.7 Check the oil level in the hydrostatic drive
Remove the side wall (Pos. 59)
The leveling container (Pos. 60) must be filled to the
middle of the drain hose.
If required, add drive oil 20W50.
60
63
To Next Page
Loading...