Lite-Check INSPECTOR 920 - Set-Up Procedures

LITE-CHECK INSPECTOR 920
Page: 13 of 36
 LITE-CHECK 311R 12VDC Regulated Power Supply
 330A Pedal Actuator
 301m Service Truck Kit
o Kit Includes
 2 – 20ft Air Lines
 1 – 20ft 7-Way Cable With 7-Way Plugs On Both Ends
 Air filter regulator for the service truck
 302A Shop Accessory Kit
o Kit Includes:
 2 – 8ft Air Lines
 1 – 8ft 7-Way Cable With 7-Way Plugs On Both Ends
 1 – Filtered Air Regulator
 Model 300k Shop Kit –
o Kit Includes:
 1 – Knock Down 4-Wheeled Cart with Air Lines
 1 – 8ft 7-Way Cable With 7-Way Plugs On Both Ends
 2 – 8ft Air Lines
 1 – Filtered Air Regulator
 Necessary hardware for an easy set-up for the shop.
Set-Up Procedures
The following steps should be taken to ensure proper setup of the INSPECTOR 920:
1. Review the Operators Manual (this manual) and the Quick Reference Guide
2. Mount the Tester securely
3. Connect the INSPECTOR 920 Tester to a 12 Volt, 20 AMP capability power
supply
Warning: A 12 volt battery charger or simple inverter cannot be used, applied
power must be clean (filtered and regulated) and capable of generating 20amp
4. Connect the air supply through a filtered regulator, to the tester on the side panel
(110 to 120 psi is recommended)
5. Connect red battery clamp or ring terminal to the positive output
6. Connect black battery clamp or ring terminal to the negative output