Lite-Check INSPECTOR 920 - Circuit Condition Messages

LITE-CHECK INSPECTOR 920
Page: 21 of 36
Circuit Condition Messages
Note: LITE-CHECK automatic testers are “live” in that any changes in circuit conditions
are immediately detected and displayed by the tester.
Display Details
“GOOD” – Circuit Passes
The circuit indicator light is on. The digital display
indicates the circuit under test, current draw, voltage
and a GOOD circuit.
“OPEN” – Open wire and no amperage load
The panel circuit indicator light is on and the
“OPEN” fault alarm sounds. The digital display
indicates the circuit under test, current draw, voltage
and an OPEN circuit fault.
“SHORT” – Circuit wires are in contact
The panel circuit indicator lights illuminate for all
shorted circuits, and the “SHORT” fault alarm
sounds. The digital display indicates the circuit
under test, current draw, voltage and a SHORTED
circuit fault.
“CHASSIS SHORT” – Circuit wire is in contact
with chassis, frame, return or ground check.
The panel circuit indicator light is on and the
“CHASSIS” fault alarm sounds. The digital display
indicates the circuit under test, current draw, voltage
and a CHASSIS circuit fault.