LitterMaid LM2680 - Litter Tray Deep Cleaning

Litter Tray Cleaning
Note ： It is not necessary to clean the tray each time you refill. Litter tray
cleaning is recommended once a month.
1. To remove the litter tray for cleaning, check to make sure the rake is in
home position.
2. Turn the ON/OFF/CLEAN switch to OFF.
3. Unplug the unit to prevent accidental activation.
4. Lift the latches on both sides of the unit (M). This will
separate the litter tray from the top housing.
5. Lifting by the sides, move the top housing off and away
from the litter tray (N).
6. Dispose of any used litter in the litter tray. To ensure
proper disposal of litter, follow manufacturer ’ s
instructions on litter package.
7. Wipe the litter tray with a damp cloth. If further
cleaning is necessary, the litter tray can be fully
immersed in water and washed with a mild
detergent.
8. Wipe the top housing with a clean cloth, paying close attention to the rake
track rails on either side of the top housing. If the rails have any litter
caked on, use a soft, damp cloth to clean. Note ： Keeping these tracks clean
will ensure the rake functions properly.
Important ： Do not soak or immerse top housing in water.
9. Dry litter tray thoroughly before reassembling.
Tip ： Before reassembling, you can spray the inside of the litter tray
surface with nonstick cooking spray or silicone spray and wipe with a soft,
dry cloth. This will help to prevent clumps from adhering to surface of the
tray,
10. Place the litter tray on a flat surface. Carefully lower top housing onto the
litter tray.
11. Lock the two latches by pressing lower part of each latch firmly against
tabs on the litter tray until each latch clicks and locks into place.
14