LitterMaid LM2680 - How to Use Your Litter Maid Box; Initial Setup and Preparation; Waste Receptacle Setup

How to Use
GETTING STARTED
Notes No tools required for setup.
1. Unpack all parts and accessories listed in the LITTER BOX PARTS section of
this Use & Care manual. If applicable, remove any stickers.
2. Find a location for your LitterMaid® Self-Cleaning Litter Box in a clean,
dry place.
Notes For optimal performance, do not place your LitterMaid Self-Cleaning
Litter Box in a moist environment or in direct sunlight.
3. Remove packing material from rake.
PREPARING THE WASTE RECEPTACLE
1. Remove carbon filter from plastic sleeve. Peel
off paper strip to expose the adhesive. Place filter
adhesive side down in square-shaped insert in the
center of the waste receptacle lid (A).
2. Close waste receptacle compartment cover.
3. Close waste receptacle (do not latch the tabs on the
side.
4. Slide waste receptacle into place, using the plastic
channels as a guide (B). Slide in until locking tab locks
in place.