LM LM068 - Basic Configuration at Commands; Basic Configuration at Commands for Quick Reference; General Settings at Commands; UART Settings at Commands

© Copyright LM Technologies Ltd Page 21 of 41
www.lm-technologies.com
User Manual for “LM068_BLE_Peri_0204” FW
7. Basic configuration AT commands
7.1 Basic configuration AT commands for Quick reference:
This section lists the basic configuration AT commands for quick reference and the
default settings wherever applicable.
7.1.1 General settings AT commands:
Sr
no
AT command
string
Command
type
Default setting
1
AT*ADDR
Query only
--
2 AT*NAME Query and set
3
AT*UPDATENAME
Query and set
ON
4 AT*ECHO Query and set ON
5 AT*RESP Query and set ON
6
AT*VER
Query only
--
7
AT*RESET
Execution only
--
8 AT*SETTINGS Query only Refer command
details
7.1.2 UART settings AT commands:
Sr
no
AT command
string
Command
type
Default
setting
1
AT*BAUD
Query and set
19200 (5)
2
AT*PAR
Query and set
No parity (0)
3 AT*STOP Query and set One stop bit (0)
4 AT*FLOW Query and set Off
5 AT*UARTCONF Query and set Throughput
7.1.3 Firmware Upgrade AT commands:
Sr
no
AT command
string
Command
type
Default
setting
1
AT*UPGRADE
INT
Query and set
UART
interface
2
AT*UPGRADE Execution only --