LM LM068 - At*Ver\R\N; At*Reset\R\N

© Copyright LM Technologies Ltd Page 24 of 41
www.lm-technologies.com
User Manual for “LM068_BLE_Peri_0204” FW
users as the user will not get any response if incorrect AT
command strings are entered.
ix. Below is the sequence of messages when ECHO and RESP are ON.
at*echo=?at*echo=?
OK
REP*:ECHO=ON
at*resp=?at*resp=?
OK
REP*:RESP=ON
at*name=?at*name=?
OK
REP*:NAME=068LM_SPP_0104
x. Below is the sequence of messages when ECHO is OFF and RESP
is ON.
at*echo=offat*echo=off
OK
at*echo=?OK
REP*:ECHO=OFF
at*resp=?OK
REP*:RESP=ON
at*name=?OK
REP*:NAME=068LM_SPP_0104
xi. Below is the sequence of messages when ECHO and RESP are
both off. The LM device will show only reports for the query
commands. The LM device will not show any indication messages
for connect or disconnect. This is to ensure backwards
compatibility with LM048/LM058/LM072 adapter/module firmware.
at*resp=?REP*:RESP=OFF
at*echo=?REP*:ECHO=OFF
at*name=?REP*:NAME=068LM_SPP_0104
7.2.6 “AT*VER”\r\n
i. Query only command
ii. Firmware version query: “AT*VER=?”\r\n
iii. Firmware version query report:
“REP*:VER=068LM_BLE_PERI_02.01”.
at*ver=?at*ver=?
OK
REP*:VER=068LM_BLE_PERI_02.01
7.2.7 “AT*RESET”\r\n
i. Execution only command
ii. LM devices supports execution of two “Reset” levels
iii. “AT*RESET=1”\r\n
1. LM device applies soft reset and starts execution as if
applied power on-off cycle.
2. LM device retains all user modified settings
3. LM device causes disconnection of all Bluetooth/BLE
connections