© Copyright LM Technologies Ltd Page 31 of 41
www.lm-technologies.com
User Manual for “LM068_BLE_Peri_0204” FW
Once the LM device completes the pairing procedure successfully
the BLE device is added to its white list. Then the LM device can
use the setting “AT*LESEC=ON” for further connections with the
same device.
8.2.2 “AT*CLRWHITE”\r\n
i. Execution only command.
ii. This command is used to delete all the devices from BLE paired
devices list i.e. White list.
iii. Command format is “AT*CLRWHITE”
iv. Adapter responds OK and deletes all the BLE paired devices from
the whitelist.
8.2.3 “AT*LEBOND”\r\n
i. Query and Set command.
ii. This command is used to read or modify the bonded device
address.
iii. LEBOND address is the address of the remote GAP-Central device
to which the BLE adapter is bonded.
iv. If the BLE BOND address is 0000-00-000000 then BLE adapter is
not bonded to any device and can accept connection request from
any device.
v. If LEBOND has valid address then BLE adapter will accept
connection requests from that device only.
vi. Query command is “AT*BOND=?”\r\n.
vii. Refer below AT commands
at*lebond=?at*lebond=?
OK
REP*:LEBOND=0000-00-000000
at*lebond=34c9f0891892at*lebond=34c9f0891892
OK
at*lebond=?at*lebond=?
OK
REP*:LEBOND=34c9-f0-891892
at*lebond=000000000000at*lebond=000000000000
OK
at*lebond=?at*lebond=?
OK
REP*:LEBOND=0000-00-000000
8.2.4 “AT*LECONFIG”\r\n
i. Query only command.
ii. LECONFIG command reads the basic configuration on the BLE
adapter for BLE role.
iii. Query command to query the setting is “AT*LECONFIG=?”.
iv. Query report is
at*LECONFIG=?at*LECONFIG=?
OK
GAPROLE=GAP_PERIPHERAL
To Next Page
Loading...