LNS 326 S2 - Default Chapter; Table of Contents

START UP MANUAL 1
HYDROBAR EXPRESS 326 S2
E-1
TABLE OF CONTENTS
1. PUTTING THE BAR FEED SYSTEM INTO OPERATION 1
2. SETTINGS RELATED TO INSTALLATION 3
2.1 End of bar position 3
2.2 Top-cut position 5
3. SETTINGS RELATED TO BAR STOCK AND MACHINED PARTS 7
3.1 Parameters 7
3.2 Mechanical settings 10
4. PUTTING THE LATHE INTO OPERATION 15
4.1 Spindle reduction tubes 15
4.2 Shaped bars (hex and square) 16