To Next PageTo Next PageWhat to do if LNS Industrial Equipment shows Alarm 3 – Servo Alarm?
If you encounter a Servo Alarm on your LNS Industrial Equipment, try powering down the bar feed for two seconds and then powering it back on. Also, inspect the equipment for any mechanical obstructions and check the bar stock for burrs.
Why does my LNS Industrial Equipment show Alarm 1 – Emergency Stop Line Open?
If you're getting Alarm 1 on your LNS Industrial Equipment, it means the Emergency Stop Line is open. You should check the emergency stop switches on the remote pendant and electrical cabinet door. Also, check the lathe emergency stop (interface connectors 7&8), motor protection switches QM1 (oil pump) and QF1 (servo drive), the main access cover safety switch (terminal connectors No.10/12), and relay K1 (servo drive power relay).
General| Brand | LNS |
|---|---|
| Model | Alpha ST 320 |
| Category | Industrial Equipment |
| Language | English |
Explains manual structure, page numbering, and cross-references.
Outlines copyrights, liability disclaimers, and trademark information.
States compliance with relevant directives and standards for the product.
Provides essential safety guidelines for operating and handling the equipment.
Details the various safety features integrated into the bar feeder system.
Lists key technical specifications like bar diameter, weight, dimensions, and power requirements.
Provides layout information and dimensions for system placement.
Details procedures for transporting the bar feeder and its crate dimensions.
Provides a general overview of the steps required for setting up the equipment.
Step-by-step guide for installing the bar feeder system.
Illustrates the layout of electrical elements within the system and control cabinet.
Explains power and signal connections between the bar feeder and the lathe.
Defines common electrical symbols used in diagrams and their corresponding designations.
Presents schematic diagrams of the electrical system for reference.
Describes the pneumatic elements and their functions in the bar feeder system.
Outlines routine weekly maintenance tasks for the pneumatic system.
Shows the schematic diagram of the pneumatic system for understanding operation.
Explains the function and maintenance of the hydraulic system, including oil requirements.
Provides a diagram illustrating the hydraulic circuit of the bar feeder.
Describes the function and adjustment of the guiding channel and pusher components.
Explains the operation of the loading rack and the vise mechanism.
Covers the drive system and the length measurement device for bar feeding.
Details the anti-vibration feature and the remnant drawer for operational efficiency.
Describes the functions and layout of the remote control unit for operating the bar feeder.
Details manual operation steps for guiding channels open and closed states.
Explains how to use the TD-200 display for parameter settings and mode selection.
Lists common alarm messages and provides solutions for troubleshooting issues.
Lists and illustrates spare parts for the magazine rack assembly.
Details spare parts for the rack cover.
Lists and illustrates spare parts for the extraction device.
Details spare parts for the chassis assembly.
Lists spare parts for the cover.
Lists spare parts for the hydraulic tank.
Details spare parts for the chain drive assembly.
Lists and illustrates spare parts for the bar measuring system.
Details spare parts for the pusher lifting system.
Lists and illustrates spare parts for the front rest.
Details spare parts for the upper channel.
Lists and illustrates spare parts for guiding elements.
Provides an example of programming sequences for the bar feeder.
A form for ordering spare parts or additional equipment.
Lists contact information for LNS agencies worldwide.
