LNS QUICK LOAD SERVO S2 User Manual

ENG
MADEINUSA

LNS QUICK LOAD SERVO S2 Specifications

General

Brand	LNS
Model	QUICK LOAD SERVO S2
Category	Industrial Equipment
Language	English

Summary

Starting the Bar Feed System

Description

General overview of the bar feed system setup procedures.

Settings Related to Installation

End of Bar Position

Defines the moment the bar feed enters the loading cycle.

Top-cut Position

Sets the bar position outside the spindle for cutting.

Settings Related to Bar Stock and Machined Parts

Example 1: Start-up for Round Bars

Configuration steps for setting up the system for round bar stock.

Example 2: Start-up for Hexagonal Bars

Configuration steps for setting up the system for hexagonal bar stock.

Example 3: Start-up for Square Bars

Configuration steps for setting up the system for square bar stock.

Example 4: Start-up for Bars of Special Profile

Configuration steps for setting up the system for special profile bar stock.

Mechanical Settings and Optional Accessories

Feeding Pusher

Details pusher types, ranges, replacement, and mechanical stop.

Calibration of the Loading Table

Procedure for calibrating the loading table for optimal bar centering.

Slope of the Magazine Table

Adjusting the magazine table slope for different bar profiles.

Loading Fingers Set-up

Adjusting the loading fingers for correct bar loading.

Putting the Lathe into Operation

Spindle Reduction Tubes

Explains the use and selection of spindle reduction tubes for bar guiding.

Shaped Bars (Hex and Square)

Handling of shaped bars with and without spindle orientation.