Need help?Do you have a question about the LNS Quick Load Servo 80 and is the answer not in the manual?
Details various alarms the bar feeder may generate, their causes, and solutions.
Details the 'Emergency stop line open' alarm, its causes, and solutions.
Explains the 'Main access cover open' alarm, its causes, and how to resolve it.
Describes the 'Magazine protection grid open' alarm and its troubleshooting steps.
Covers the alarm for the bar feeder not being in its working position, with solutions.
Addresses the 'Measuring cell SQ3 signal defective' alarm and its possible causes.
Details the 'Home position proximity switch SQ5 signal missing' alarm and resolution.
Explains the alarm related to the loading channel's motion time limit being exceeded.
Describes the 'Measuring cell SQ3 activated too early' alarm and its causes.
Details the 'Bar stock loading error' alarm and its causes.
Explains alarms related to communication faults between servo amplifier and PLC.
Covers alarms originating from the servo amplifier and their basic resolution.
Describes the 'Servo motor not ready' alarm and troubleshooting steps.
Explains the 'Servo motor positioning error' alarm and its causes.
Detailed explanations of alarm definitions, causes, and corresponding actions.
Details the servo motor following error alarm during sequence 9 and its causes.
Step-by-step guide for aligning the bar feeder with the lathe.
General| Brand | LNS |
|---|---|
| Model | Quick Load Servo 80 |
| Category | Industrial Equipment |
| Language | English |
To Next Page