LNS Quick Load Servo 80 - A28 - Parts counting parity error by M-code quantity and automatic part counting

CHAPTER 1: ALARMS 1-18
A28 – Parts counting parity error by M-code quantity and automatic part
counting
PARTS COUNTING
PARITY ERROR BY
M-CODE QUANTITY AND
AUTOMATIC PART
COUNTING
A28
Description:
The « Parts counting parity error by M-code quantity and automatic part counting » alarm occurs
whenever clamping device openings quantity does not match the value « number of clamping device
openings » while the input (I43 – A4) is activated.
Solution:
Press the STOP button on the remote control to reset the alarm.
Restart the automatic cycle of the bar feeder and the lathe.
QUICK LOAD SERVO 65/80