LNS Quick Load Servo 80 - A25 - Lathe did not resume its production cycle

CHAPTER 1: ALARMS
QUICK LOAD SERVO 65/80
1-15
A25 – Lathe did not resume its production cycle
LATHE DID NOT
RESUME ITS
PRODUCTION CYCLE!
A25
Description:
The « Lathe did not resume its production cycle » alarm occurs when the bar feeder does not detect the
clamping device signal (I40 – A1) within the minute following the reach of the top cut positioning.
Solution:
Press the STOP button on the remote control to reset the alarm.
Restart the automatic cycle on bar feeder and lathe.