1 Service
13
Service Manual
Initial Setup Screen
Figure 1-1 Settings
Initial Setup
Clock and Date
The control uses an internal clock for the night setback
feature and for logging of events. For these features to work
correctly, the clock must be set when the appliance is first
installed or anytime the appliance has been powered off for
more than four (4) hours. This parameter must be accessed
to set the clock. If the unit is connected to the internet, the
time will adjust based on the time zone selected.
Temperature units (°C / °F)
The control can be configured to display temperature in
either °C or °F.
Set clock
The SMART TOUCH control has a built-in clock that it uses
for its night setback feature and for logging events. This clock
must be set when the appliance is installed and anytime the
appliance has been powered off for more than four (4) hours.
Use the following procedure to set the clock:
1. Press the SETTINGS button under the Lochinvar logo
(see FIG. 1-1).
2. Press the SET button across from the date and time (see
FIG. 1-1).
3. Proceed to set the date, time, and time zone.
NOTE: Automatic Time Zone will not work.
4. Temperature units and WiFi may also be set here. These
items may be used to automatically sync the time.
5. Press the Home, View, or Back button to exit.
To Next Page
Loading...
Need help?
General
