READ AND UNDERSTAND THE INSTRUCTIONS
Read and fully understand all instructions before attempting to operate maintain or install the unit.
Keep these instructions near the water heater for quick reference.
This equipment must be installed by a competent person, registered with the H.S.E. approved body. All installations must
conform to the
relevant Gas Safety and Building Regulations. Health & Safety requirements must also be taken into
account when installing any equipment.
Failure to comply with the above may lead to prosecution
Without written approval of the manufacturer the internals of the water heater may not be changed. When changes are executed without approval,
the water heater certification becomes invalid.
Commissioning, maintenance and repair must be done by a skilled installer/engineer, according to all applicable standards and regulations.
2.1 GENERAL DESCRIPTION OF SAFETY SYMBOLS USED
ELECTRICAL HAZARD
Observe all signs placed next to the pictogram. The symbol indicates components of the unit and
actions described in this manual that could create an electrical hazard.