3.3 Adding an Access Code
SECTION 3.3
While in Programming Mode,
select “1AD” to add an
Access Code. If you are not
in Programming Mode,
please see Section 3.2 to
enter Programming Mode.
After pressing “1AD” to add
an Access Code.
Enter your new 6 - 8 digit Access Code and press
when you are finished. You will then re-enter the code to
confirm your new Access Code.
Remember, just touch the digit you need within the circle
around each 3 numbers. There is no need to touch the
exact location of the number. For example, based on the
example image to the left, if you need “1”, you can touch
the upper left button. For “6”, you would touch the upper
right button.
11
To Next Page
Loading...
Need help?
General
