3.4 Deleting an Access Code
SECTION 3.4
While in Programming Mode, select “2DE” to delete an
Access Code. If you are not in Programming Mode,
please see Section 3.2 to enter Programming Mode.
After pressing “2DE” to delete an Access Code.
OK Button
Example Only
Active Access Codes will then be displayed on the
screen in sequence from left to right, top to bottom. In
the example shown on the left, the Access Code
displayed is 1 3 5 7 9 0 .
Rotate through different Access Codes shown by touch-
ing any number on the screen. If you find the Access
Code
you want to delete, simply hold the OK Button for 3
seconds.
(Continue on next page)
13
To Next Page
Loading...
Need help?
General
