4.5 Safe Mode - Overview
SECTION 4.5
Lockly
®
will enter Safe Mode when three (3) consecutive wrong Access Codes are entered
within
5 minutes. When in Safe Mode, the lock status icon will start to flash.
To disable Safe Mode, you must unlock the door using the correct fingerprint or
enter the
correct Access Code twice in a row. Activate the keypad by pressing and holding
for
3 seconds.
Once the screen is activated, enter the correct Access Code carefully twice, pressing
after
every time.
If you enter the wrong code, the keypad will then be disabled for 10 minutes.
Countdown Prompt
(Displayed in Minutes)
Will start with 10 and
countdown until 0.
You will see a “10” on the screen, notifying the number of minutes that the keypad is
disabled for. After 10 minutes, you may attempt to enter the correct Access Code to
unlock the door. After the second incorrect attempt to unlock the lock with the wrong
Access Code, Lockly
®
will disable the keypad for 20 minutes, displaying a “20” on the
screen. After the third wrong attempt to unlock the door with the correct Access Code,
the screen will be disabled for 30 minutes. (Example A and Example B above).
Note: In order to conserve power, the countdown prompt will only be displayed for 3
seconds. You can reactivate the screen by sliding your hand across the screen.
Example A Example B
21
To Next Page
Loading...
Need help?
General
