9
6 Care, Cleaning, and Maintenance
5. Dispensing (continued)
5.3 Returning to Operation
The rotorspray is automatically switched on at the wetting position by the Controller 97123. The
dispensing takes place automatically after the rotor reaches the rated speed and according to the
preselected dispensing time.
Returning to Operation after Longer Periods of Non-use
• Check the installation, according to Section 4.
• Return to operation, according to Section 5.1.
☞
6.1 Cleaning
The unit requires no special care and maintenance.
Cleaning
• For periods of inactivity of more than 14 days or when changing the type of product, remove and
clean the rotor disc and its shaft.
Use recommended cleaning agents according to the operating instructions of the stationary
applicator.
☞
To Next Page
Loading...
