Loewe bild 4 - Page 30

Loewe bild
User handbook
30

Initial installation
Setting options for the satellite system (other communal
installation):
 Select satellite.
OK Confirm selection.
 Proceed to next step.
 Select and adapt settings.
OK Confirm selection.
LNC
frequency
Normally, you do not need to change the values for
high and low band, unless the LNC (LNB) of your
satellite system uses a different oscillator frequency
(important for the frequency display).
Supply
voltage
If your set is connected to a single-cable system
without external voltage supply, you can connect
the antenna supply (13V or 18V / max. 500mA).
 Proceed to next step.
Proceed to section Setting options for all types of
reception.
Select
single satellite
LNB
frequencies,
Supply
voltage