Logan Graphic Products 650-1

Questions and Answers

J
Jill HolmesJul 27, 2025
Why is my Logan Graphic Products 650-1 not cutting through the material?
- I
  ismithJul 27, 2025
  Your Logan Graphic Products Cutter might not be cutting through because it is not on a level surface, so place the machine on a level surface. Another reason might be that you are not using a Slip Sheet that is at least as long as the mat you are cutting, so use a Slip Sheet that is at least as long as the mat. Finally, the blade depth might be set too shallow, so adjust the blade depth.
O
owensmatthewAug 1, 2025
How to fix hooks or curves when using Logan Graphic Products 650-1 Cutter?
- M
  Mark SweeneyAug 1, 2025
  If you notice hooks or curves when using your Logan Graphic Products Cutter, it could be due to several reasons. First, the blade depth might be set too deep, so adjust the blade depth. Second, the blade may be dull, so replace the blade. Third, the blade might be catching on a previous cut in the Slip Sheet, so ensure the Slip Sheet is clean. Lastly, you might be applying uneven pressure to the Cutting Head during the cut, so apply even pressure during the cut.
J
Joshua CalhounAug 6, 2025
What to do if I get a ragged bevel cut with my Logan Graphic Products 650-1 Cutter?
- P
  Paul GrantAug 6, 2025
  A ragged bevel cut with your Logan Graphic Products Cutter can occur for a few reasons. You might be cutting without a Slip Sheet, so use a Slip Sheet. It could also be that the Slip Sheet is worn out, so replace it. Additionally, you may not be changing the blade often enough, so change the blade more frequently.
M
melissabryantAug 11, 2025
Why are the mat borders uneven when using my Logan Graphic Products Cutter?
- F
  Frank ShermanAug 11, 2025
  Uneven mat borders when using your Logan Graphic Products Cutter are likely because the Mat Guide is not parallel. Adjust the Mat Guide to be parallel to resolve this issue.
W
Wesley CrosbyAug 16, 2025
What to do if there is an overcut on the top cut with my Logan Graphic Products 650-1?
- G
  Gloria BurnettAug 16, 2025
  If you are experiencing an overcut on the top cut with your Logan Graphic Products Cutter, the blade depth might be set too deep. Adjust the blade depth to correct this.
M
Mark ReedAug 21, 2025
How to avoid overcut on bottom cut with Logan Graphic Products 650-1?
- L
  Larry PierceAug 21, 2025
  If the overcut is too small - align start and stop indicator slightly below pencil line and cut. If the overcut is too big - align start and stop indicator slightly above pencil line and cut.