Logia LOGLP300 - Loading and Cleaning Your Label Printer; Label Loading Procedure; Printer Head Cleaning Guide

@ LOADING YOUR LABEL PRINTER
Once you have selected your desired paper size, here's how to load your Logia™
300 DPI Label Printer:
5028 |
jI—— —0
rm 50 ——
50
Ie )
Turn the power OFF Press the cover release Load your labels, ensuring that they are
atches to open the top cover flush against the papel fee guides on either
side. The backing that gets peeled off
should be facing up (toward the ceiling)
eo
20562
5 30
c
Gently close the cover until Turn the power ON and wait Press and hold the paper feed button until
it clicks 5 seconds you hear a Dee Now you may an feed
additional labels of the same size through
the back instead of re-opening the printer
@ CLEANING THE PRINTER HEAD
NOTE: Ensure the printer is turned off and unplugged before cleaning. Allow the printer
head to cool down before attempting this process. Do not touch or scratch the printer head
surface, roller, or sensors. Do not use harsh solvents such as gasoline or acetone.
1. With the printer off and unplugged, and the printer head cooled down, press
the cover release latches to open the top cover.
2. Useaclean cotton swab and rubbing alcohol to clean the printer head
gently and thoroughly.
ait until the slecha has completely evaporated before re-closing the
top cover.
Plug the printer back in and turn the power on, then print a test page to
ensure that the printer head is now clean.
=
fo