LOGICDATA SMARTneo-2G - Adjusting the Table Top Height; Saving a Memory Position; Using a Basic Hand Control

SMARTNEO OPERATING MANUAL // PAGE 22
7.1 ADJUSTING THE TABLE TOP HEIGHT
CAUTION Risk of minor or moderate injury through crushing
Your ngers may be crushed when you attempt to change the height of the table.
• Keep ngers away from moving parts
• Ensure that no persons or objects are in the table‘s range of motion
INFO The Table Top will move up or down until the UP or DOWN Key is released, or if a pre-
dened stopping point has been reached.
To move the Table Top UP:
Press and hold the UP Key until the desired height has been reached
To move the Table Top DOWN:
Press and hold the DOWN Key until the desired height has been reached
7.2 SAVING A MEMORY POSITION
7.2.1 USING A BASIC HAND CONTROL
This function saves a set Table Top position. One “Stand” Memory Position can be saved in the top half of the
range of movement, one “Sit” Memory Position in the bottom half.
1. Move the table to the desired height (Chapter 7.1, Adjusting the Table Top height)
2. Press and hold the UP Key and DOWN Key simultaneously (“S” Key if available)
3. Press the UP Key to Save a Standing Position or the DOWN Key to Save a Sitting
Position.
▸ The Memory Position is saved
To delete a Memory Position with a Basic Hand Control, move to the Memory Position you wish to delete
and repeat steps 2 and 3.