SMARTNEO OPERATING MANUAL // PAGE 29
▸ Press the SAVE Key.
7
3
▸ The height display is now set to the new Table Top height (e.g. 73 cm).
8.6 CHANGING THE DISPLAYED UNIT OF
MEASUREMENT (CM / INCH)
Comfort Hand Controls can display the height of the Table Top in both centimeters and inches. To change
the displayed unit of measurement:
1
2
1. Press and hold the following Keys for 3 seconds:
• Memory Position Keys 1 and 2
• UP Key
S
7
▸ The display shows S and a number (e.g. S 7)
2. Press the DOWN Key until the display shows S 5.
S
5
▸ The display shows S 5.
3. Press the SAVE Key.
▸ If the display was previously set to cm, it is now set to inches.
▸ If the display was previously set to inches, it is now set to cm.
8.7 DUTY CYCLE MONITORING
Duty Cycle Monitoring causes a system shutdown when the maximum Duty Cycle is reached. The Duty
Cycle limits can be found in the product‘s Datasheet.
To Next Page
Loading...
Need help?
General
