LOGICDATA SMARTneo-2G User Manual

SMARTNEO OPERATING MANUAL // PAGE 38
11.2.3 DISABLING SENSOR DETECTION (S3 MENU)
INFO In Cascading Systems, you must perform this function in single mode for each Control
Box in the system.
INFO This process is “resistant” to the Factory Reset. This means that resetting to Factory
Settings will not aect the on/o status of the sensor.
In certain assembly variants, it may not be possible to achieve accurate readings from the integrated sensor.
In this case, it is possible to manually switch the ISP sensor on and o. LOGICDATA does not reccomend
using the Control Box without a functioning ISP sensor. To avoid system damage, the ISP sensor should only
be switched o when absolutely necessary, and only with prior approval from LOGICDATA.
To enable or disable the ISP sensor:
1 2
1. Press and hold the following Keys for 3 seconds:
• Memory Position Keys 1 and 2
• UP Key
S
5
▸ The display shows S and a number (e.g. S 5)
2. Press the UP Key until the display shows S 3.
S
3
▸ The display shows S 3.
3. Press the SAVE Key.
▸ The display will show the current o/on status of the ISP sensor (1 for on, 0
for o.).
4. Select the desired o/on status of the ISP sensor (1 for on, 0 for o.) with the UP
or DOWN Key.
5. Press the SAVE Key to conrm the changes to settings.
▸ The Control Box will click twice.
6. Perform a Position Reset Procedure to complete the change (Chapter 6.7)

LOGICDATA SMARTneo-2G Specifications

General

Brand	LOGICDATA
Model	SMARTneo-2G
Category	Control Unit
Language	English