What to do if my LOGICDATA Control Unit shows error E93?
If your LOGICDATA Control Unit displays error E93, it might be due to cascading errors. First, check all plug connections and cables, replacing any defective ones. If the problem persists, inspect the Control Boxes themselves and replace any that are faulty.
What to do if the LOGICDATA Control Unit user interface does not work?
If the user interface isn't working, it could be defective or not properly connected. Ensure that the user interface is correctly connected to the control box. If the problem continues, the user interface likely needs to be replaced.
What does error E00 mean on my LOGICDATA SMARTneo-2G Control Unit?
Error E00 indicates an internal error has occurred. To resolve this, consult the error code table to find the appropriate response for the specific error code displayed.
Why does my LOGICDATA SMARTneo-2G table only move downwards?
The table might only be moving downwards because of a power failure during motion or a defective actuator. In the event of a power failure, perform a position reset procedure. If the issue continues, the actuator may need to be replaced.
What to do if my LOGICDATA SMARTneo-2G shows error E7O?
If the LOGICDATA Control Unit shows error E7O, it might be because the actuator configuration has been changed. To resolve this, disconnect the Control Boxes from the power supply for about 30 seconds. Then, reconnect them and perform a Reference Drive.
What does E60 error 'ISP Activated' mean on LOGICDATA Control Unit?
Error E60 means ISP is activated. Release all keys and wait for the drive back function to complete.
How do I fix the E55 error 'Sync Error, Motor Group 1' on my LOGICDATA SMARTneo-2G Control Unit?
To fix the E55 error, remove any excess load from the table and perform a factory reset.
What to do if I get E56 error 'Sync Error, Motor Group 2' on LOGICDATA SMARTneo-2G Control Unit?
If you get error E56, remove any excess load from the table and perform a factory reset.
What does E62 error 'Stop due to power output control' mean on LOGICDATA Control Unit?
The E62 error means the system stopped due to power output control. Make sure nothing is blocking the table's movement and that you remove any excess load from it.
What does error E25 'Overcurrent Motor M2' mean on a LOGICDATA Control Unit?
Error E25 indicates an overcurrent in motor M2. Check that nothing is obstructing the table's movement and remove any excess weight from the table.
General| Standby Power Consumption | < 0.3 W |
|---|---|
| Number of Drives | 2 |
| Hall Sensor | Yes |
| Operating Temperature | 0°C to +40°C |
| Ambient Temperature | 0°C to +40°C |
| Protection Class | IP 20 |
| Communication Interface | Bluetooth |
| Weight | 300 g |
To Next Page
