What causes E65 error 'Overcurrent while driving' on LOGICDATA Control Unit?
The E65 error indicates an overcurrent while driving. Check that nothing is blocking the table's range of movement and remove any excess load from the table.
How to resolve E13 error 'Defect Channel 2' on LOGICDATA SMARTneo-2G?
To resolve error E13, disconnect the control box from the mains. Fix any external short circuits and ensure all cables are connected correctly. Reconnect the system, then operate as normal.
How to fix E12 error 'Defect Channel 1' on LOGICDATA Control Unit?
To fix error E12, disconnect the control box from the mains. Then, fix any external short circuits and ensure all cables are correctly connected. Finally, reconnect the system and operate as normal.
What does 'Hot' mean on my LOGICDATA Control Unit display and how to fix it?
If the display shows 'Hot', it indicates that the duty cycle might be exceeded, causing components to overheat. Allow the components to cool down before resuming operation.
Why does my LOGICDATA SMARTneo-2G table only move downwards?
The table might only be moving downwards because of a power failure during motion or a defective actuator. In the event of a power failure, perform a position reset procedure. If the issue continues, the actuator may need to be replaced.
What does error E00 mean on my LOGICDATA SMARTneo-2G Control Unit?
Error E00 indicates an internal error has occurred. To resolve this, consult the error code table to find the appropriate response for the specific error code displayed.
What to do if the LOGICDATA Control Unit user interface does not work?
If the user interface isn't working, it could be defective or not properly connected. Ensure that the user interface is correctly connected to the control box. If the problem continues, the user interface likely needs to be replaced.
General| Standby Power Consumption | < 0.3 W |
|---|---|
| Number of Drives | 2 |
| Hall Sensor | Yes |
| Operating Temperature | 0°C to +40°C |
| Ambient Temperature | 0°C to +40°C |
| Protection Class | IP 20 |
| Communication Interface | Bluetooth |
| Weight | 300 g |
To Next Page
