12
FM Operation
Switching from DAB to FM Mode
In order to switch the unit from DAB to FM mode, press the DAB/FM button once. The display
shows “Switching to FM”.
On the top line of the display is the current frequency. On the bottom of the display,
<Programme Type> will show since no channel is tuned in and no RDS (radio data system) data
is available.
Auto Scan
To search for an FM station, you need to press and then release the AUTO button. This will start
scanning up the frequency band. To scan down the frequency band, press and hold the AUTO
button. Once a station has been found, the scanning will stop automatically.
If no station is found, then the tuning will stop once it has cycled through the entire FM band
(87.5-108MHz).
Manual Scan
To search FM stations manually, simply press the PREV or NEXT button repeatedly until your
desired frequency is reached.
Storing Stations
You can store up to 10 of your favourite stations to the memory. This will enable you to access
your favourite stations quickly and easily.
1. To store a preset, you must rst be listening to the station that you would like to save,
then press and hold the PRESETS button.
2. Press the PREV or NEXT button to select your desired preset station number.
3. Press the SELECT button to conrm the selection.
4. The station will be stored and the display will then show “Preset # stored“.
Recalling a Stored Station
1. Once you have saved a station to one of the preset buttons, you can recall it by pressing
the PRESETS button.
2. Press the PREV or NEXT button to select your desired preset station number.
3. Press the SELECT button to conrm the selection.
4. If you choose a preset that hasn’t been allocated a station, the display will show “Preset
empty #“.
Select Sensitivity in FM
1. Press and hold the SELECT button for 2 seconds.
2. Show 1-10 level, press the PREV or NEXT button to select the sensitivity manually.
L22DAB10_IB_final110826_adaptor change.indd 12 26/08/2011 10:24 AM
To Next Page
Loading...
