18
GB
Initial Setup
6. Channel tuning will commence. This operation may take up to 6
minutes. The display will show the progress of the tuning and the
number of channels found.
7. If you want to skip the ATV tuning, press the MENU button to
interrupt the tuning half way. A pop-up screen will be displayed,
press the
button to select YES to confirm. You will then go
straight to DTV tuning. You may repeat the above step if you also
want to skip the DTV tuning. An installation reminder will appear
the next time you turn on the TV.
8. After tuning is complete, the channels are arranged in the
broadcaster's preset order. If you wish to skip channels, modify
the preset order or rename channels, select Channel Edit under
the Channel menu (refer to page 22-23 for details).
Channel Tuning
TV : 0 Channel
DTV : 0 Channel
Radio : 0 Channel
Data : 0 Channel
1 %... 471.25 MHz (TV)
Please press MENU key to skip
5. Press the buttons to navigate the menu and change the
settings. Press the OK button to confirm.
OSD Language Select your desired language to be displayed on
the menu. The default on-screen menu language
is set as English.
Country Select the country where you will operate the TV.
The default country is set as UK.
Turning the TV on for the First Time
1. Connect the mains cable to the mains socket after you have
completed all the connections.
2. Switch on the POWER ON/OFF switch which is
located on the right side under the frame. At this
stage, the TV switches to standby mode. The red LED
indicator will illuminate on the front panel of the TV.
3. In standby mode, press the
/ I button on
the top panel of the TV or the
button on the
remote control to turn the TV on. The red LED
indicator will turn blue.
4. The first time you turn the TV on, it will go straight into the First
Time Installation menu. Please ensure the aerial is plugged
in and then press the OK button. (If you have already installed
the TV using the Quick Start Guide, please go to the next step
“Selecting the Input Source” on the next page.)
Please ensure aerial is plugged in!!
Then press OK button to start
Please select an OSD Language
Deutsch
Español Français
Português Italiano
English
Country
France
Germany Portugal
Italy Spain
UK
Menu
Always disconnect the TV from the mains socket when
not in use for a long period of time.
The
/ I button on the top panel of the TV or the
button on the remote control is only used for switching
the TV into standby, it does not disconnect the TV from
the mains power. To completely disconnect the mains
power, please remove the mains plug from the mains
socket or switch off the POWER ON/OFF switch.
To the mains socket
Initial Setup
L24DVDB11_IB_110429.indd 18 29/04/2011 5:10 PM
To Next Page
Loading...
Need help?
General
