8
Battery Replacement for the Remote Control
The remote control requires a CR2032, 3V battery.
1. Slide and hold the battery release tab in the direction of the
arrow.
2. Pull out the battery holder and remove the old battery.
3. Replace with a new battery.
4. Insert the battery holder back into the remote control.
Handling the Battery
• Improper or incorrect use of batteries may cause corrosion or battery leakage, which
could cause re, personal injury or damage to property.
• Only use the battery type indicated in this manual.
• When the battery is exhausted, the remote control will not function.
• Do not dispose of the used battery as domestic waste. Dispose of it in accordance
with local regulations.
• Install the battery correctly in the battery compartment.
• Small button cell batteries such as the one used in the remote control are easily
swallowed by young children and this is dangerous. Keep loose button cells away
from young children and make sure that the battery is secure in the remote control.
Seek medical advice if you believe a battery cell has been swallowed.
Handling the Remote Control
• Take care of your ngernails when you slide and pull the battery release tab.
• Do not drop the remote control.
• Do not allow anything to impact the remote control.
• Do not spill water or liquid on the remote control.
• Do not place the remote control on a wet object.
• Remove the battery from the remote control when not in use for a long period of
time, as corrosion or battery leakage may occur and result in physical injury, and/or
property damage, and/or re.
L48ACW20_IB_Final191210V1.indd 8 11/12/2019 11:47
To Next Page
Loading...
Need help?
General
