To Next Page

To Previous Page

Installing the Batteries (Remote Control)

1. Remove the cover on the back of the remote control by

sliding the battery compartment cover o.

2. Insert 2 x AAA batteries, ensuring that their polarities (+ /

–) are pointing in the right direction.

3. Slide the cover back into place. It will click when securely

tted.

Handling the Battery

• Improper or incorrect use of batteries may cause corrosion or battery leakage, which could

cause re, personal injury or damage to property.

• Only use the battery type indicated in this manual.

• When the batteries are exhausted, the remote control will not function. Replace both

batteries at the same time with new ones.

• Do not install new batteries with used ones and do not mix dierent types of batteries.

• Do not dispose of used batteries as domestic waste. Dispose of them in accordance with

local regulations.

Handling the Remote Control

• Do not drop or cause impact to the remote control.

• Do not spill water or any liquid on the remote control.

• Do not place the remote control on a wet object.

• Do not place the remote control under direct sunlight or near sources of excessive heat.

• Remove the battery from the remote control when not in use for a long period of time, as it

could cause corrosion or battery leakage and may result in physical injury and/or property

damage including re.

LAC08C16_IB_RC_161229_grace.indd 14 29/12/16 10:06 am

Logik LAC08C16 User Manual

Questions and Answers: