15
General Operation
Adjusting the Louvre
You can adjust the louvre to the desired position manually.
Setting the Auto On/O Time
You can set the unit’s auto on/o time from the remote control only.
1. Press TIMER ON repeatedly to select the auto on time. To conrm, stop pressing and wait for
the conrmation tone.
2. Press TIMER OFF repeatedly to select the auto o time. To conrm, stop pressing and wait for
the conrmation tone. The Timer Mode Indicator will light up. The unit is now programmed to
auto on/o.
To change the auto on/o time setting, repeat from step 1.
To cancel the auto on/o time setting, set the timer to 0.0.
Using the Dry Mode
For the best dehumidifying eect, keep all windows and doors closed.
1. Remove the drain outlet plug from the back of the unit.
2. Connect one end of the drain tube to the drain outlet
opening and the other end to your drain area.
3. Press MODE and select “Dry” to start drying.
To stop drying, press MODE to switch to other modes or switch
o the unit. Make sure all water is drained before removing the
drain tube and replacing the drain outlet plug onto the back of
the unit.
Fan speed and temperature cannot be adjusted under dry mode.
Switching the Unit On/O
• Plug the unit into the mains supply. The Power Indicator will light up, indicating the unit is in
standby mode.
• Press
on the unit or ON/OFF on the remote control to switch on the unit. The Power
Indicator light will turn o.
• To completely switch o the unit, unplug from the mains supply.
• Ensure the louvre is fully opened during operation.
• Do not put objects or hands into the louvre opening.
LAC08C16_IB_RC_161229_grace.indd 15 29/12/16 10:06 am
To Next Page
Loading...
Need help?
General
