9
Audio Mode
Press the STOP / FM MONO / FM STEREO button repeatedly to switch between
AUTO or MONO modes.
For Better Reception
Fully unwind the aerial. Extend the aerial and place it in
the position that offers the best sound reception.
The unit will automatically switch between stereo and mono mode when it is set in
FM mode, but you can override this and switch between them manually. This is helpful
when signal reception is poor.
The stored stations will be saved into the memory and power off will not erase it.
Storing a new station into a preset location will erase the previously stored station in
that location.
With FM radio it may be necessary to fine tune each station by pressing SKIP+/SKIP–
repeatedly. Each press will adjust the frequency by 0.05MHz. If reception is still poor
adjust the position of the aerial or try moving the radio to another location.
Presetting Stations
You can store up to 30 of your favourite stations in the memory. This will enable you
to access your favourite stations quickly and easily.
3. To store a preset, you must first be listening to the station that you would like to
save, then press and hold the MEMORY button and the display will flash “P#“and
“MEMORY”.
4. Press the SKIP+/SKIP– buttons repeatedly to select your desired preset station
number.
5. Press the MEMORY button to confirm the selection.
Recalling a Preset Stations
1. Once you have saved a station to one of the preset buttons, you can recall it by
pressing MEMORY.
2. Press the SKIP+/SKIP– buttons to select your desired preset station number.
Manual Scan
Press SKIP+/SKIP– repeatedly until your desired frequency is reached.
To Next Page
Loading...
Need help?
General