GB-3
Introducing Your New Cooker Hood
Before use
Please read these instructions carefully before using your new Logik Cooker Hood. The Cooker Hood is for indoor,
domestic use only.
WARNING: Please be carefully when unpacking and installing this appliance as sheet metal can cause injury if not
handled with care.
Telescopic chimney ue
120mm to 125mm ducting adaptor
Ducting adaptor
Cooker hood main body
Removable lters
Control panel
Screws ST4*35 X6 ST4*18 X4 ST4*10 X2
Washers x 2
Screw plug x 6
Install Your New Cooker Hood
Installation and electrical wiring must be carried out by a qualied engineer to ensure
all appliance codes and standards are followed. Before installing check that the
voltage indicated on the rating plate is suitable for your home.
Location
The Cooker Hood is designed to be a permanent xture in the home, therefore needs to be located in a place that
the lowest part of the hood will be set at least 70cm above the hob.
The Cooker Hood will need to be positioned with adequate ventilation directly over the cooker. The air that is
discharged from the Cooker Hood should NOT be ltered into a ue that is used for other appliances that use gas
or other fuels. Regulations concerning the discharge of air MUST be fullled.
IMPORTANT: The Cooker Hood ue MUST NOT be connected to a previously installed appliance i.e. water, heaters,
boilers or cooker. The Cooker Hood MUST have a separate ue and MUST NOT be installed above a cooker with
eye-level grills.
IMPORTANT: Easy access to the electrical socket must be maintained to ensure that you can carry out simple
maintenance.
Before plugging in YOU MUST
Check that you have a socket, which is compatible with the Cooker Hood.
Rating plate
To Next Page
Loading...
