GB-6
Cleaning
Regular cleaning will help to maintain the eectiveness of your Cooker Hood.
1. Switch o and unplug the Cooker Hood before cleaning.
2. Clean the inside and outside of the Cooker Hood with a damp cloth and a mild detergent.
NOTE: Do not use solvents or abrasives as this may damage the Cooker Hood.
Warning: Your Cooker Hood can become a re risk if it is not cleaned correctly
Please be careful when cleaning this appliance as sheet metal can cause injury if not handled with case.
Cleaning the lters
To ensure the lters do not become a re hazard we recommend they are washed every 3 months. Do not check the
lter panels whilst the Cooker Hood is in use.
1. Before cleaning the lters always switch o and disconnect the electrical supply.
2. Remove the lter panels by holding down the buttons on each panel and lifting towards you. They can then
be taken out of the cooker hood.
3. Wash each lter in warm water and a mild detergent, leave to soak and drain. Ensure it is completely dry
before replacing into the Cooker Hood.
4. Place the bottom of each panel into the back of the Cooker Hood and raise the top to click into position.
NOTE: The lter panels are also dishwasher proof. The lter panels may alter in colour slightly after several washes,
this is not a fault.
To Next Page
Loading...
