13
Contents and
Safety information
Getting startedConnectionsRemote controlInitial settingBasic operationOSD operationTroubleshooting &
Specications
Insert batteries to remote control
1. Remove the battery cover of remote control.
2. Insert 2 AAA batteries in the correct position
3. Replace the battery cover.
NOTE:
• Alkaline batteries are recommended.
• Remove batteries when the remote control is not using for a long time.
• Make sure the batteries are properly aligned according to the (+) and (-) poles.
Remote control operation range
30º
30º
Remote sensor
NOTE:
• Do not point bright lights at the remote control signal sensor.
• Do not place objects between the remote control unit and the remote control signal sensor.
• Do not use this remote control unit while operating the remote control unit of other equipment.
3
2
1
• Point the remote control unit no more than 5 meters from the remote control sensor and within 60° of
the front of the unit.
• In addition, the operating distance may vary according to the brightness of the room.
To Next Page
Loading...
Need help?
General
