21
GB
Adding Salt
If the water in your area is hard, deposits will form on your dishes and utensils. As such, this
appliance contains a salt reservoir for you to reduce the hardness of the water.
Please follow the steps below to pour the salt into the salt reservoir and to correspond to the
water hardness level in your area.
1. Remove the lower basket and unscrew the reservoir cap.
2. Place the funnel provided over the salt reservoir. Pour in
approximately 1.5kg of dishwasher salt depending on the
brand used.
3. Fill the reservoir with water until it overows (rst use only).
4. Clean any excess salt from around the reservoir opening and
then screw the cap on again rmly.
5. Run the “Rapid” wash programme immediately (without any
crockery in the dishwasher) to remove any traces of salt from
the compartment.
open
open
open
• The salt rell warning indicator on the control panel will illuminate when the reservoir
is running out of salt and requires relling.
• The salt rell warning indicator will cease to illuminate within a few days, depending
on how quickly the salt dissolves.
• If you decide to use a detergent tablet, you may not need to add salt, this depends
upon the water hardness in your area and the type of tablet being used. Check with
your water supplier and the detergent tablet manufacturers instructions.
LDW60W_T20N_IB_5L_RC_Final210906.indb 21LDW60W_T20N_IB_5L_RC_Final210906.indb 21 6/9/2021 3:04 PM6/9/2021 3:04 PM
To Next Page
Loading...
