33
GB
At the End of a Programme
At the end of the programme, the dishwasher will beep.
1. Open the door a little to avoid water spillage.
2. Wait for the spray arms to stop spinning.
3. Open the door completely.
4. Let the dishes cool down before removing them, as hot dishes crack easily when hot.
Switching O the Unit
To save energy, remember to switch the dishwasher o using the On/O button. The
dishwasher will continue to use electricity until it is switched o with the On/O button.
Unloading the Dishwasher
Allowing dishes to cool down before unloading is important as dishes tend to break and chip
more easily when they are hot. Therefore, if you open the dishwasher door fully after switching
o, it will allow the dishes to cool down much faster.
Delay Start
The starting time of a washing programme can be delayed and adjusted. Please follow the steps
below.
1. Open the dishwasher door and load your soiled dishes and crockery.
2. Close the door. Press the
On/O button to turn on the dishwasher.
3. Select your preferred programme.
4. Press the
button repeatedly to select your desired delay period (range up to 24 hours).
5. Press the
button. The unit will start the programme at the assigned time automatically.
If the dishwasher is not going to be used for a long period of time, e.g. whilst on holiday,
disconnect the unit from the mains supply.
The condensation strip helps prevent the risk of steam damage to the worktop edging
above the dishwasher. It is advisable to leave the door closed until you are ready
to unload the crockery. Do not leave the door only partially open. Do not leave the
appliance unattended with the door fully open as this could present a trip hazard.
Unload the lower basket rst, followed by the cutlery basket and then the upper basket.
This will prevent water drops from the upper basket from falling on to the dishes in the
lower basket.
Each press of this button increases the delay start time by 1 hour increments.
LDW60W_T20N_IB_5L_RC_Final210906.indb 33LDW60W_T20N_IB_5L_RC_Final210906.indb 33 6/9/2021 3:04 PM6/9/2021 3:04 PM
To Next Page
Loading...
