Logik LHDR15 - System Settings; System Reset (Mains Operation Only)

15
System Reset (Mains Operation Only)
There may be times when you need to reset your unit back to the factory settings,
especially if you have moved house or if you experience reception problems.
If you move to another part of the country and pick up the local and national DAB stations
in that area, your previously tuned channels may no longer be available.
1. Press and hold the MENU/INFO button to enter the menu.
2. Press the
or button until “System” shows on
the display.
3. Press SELECT to conrm.
4. Press the
or button until “Factory Reset” shows on the display.
5. Press SELECT to conrm
6. Press the
button to select “Yes” .
7. Press the SELECT button to conrm. “Restarting...”
shows on the display. After the reset is complete,
the unit will go to standby mode.
8. Press the
STANDBY button again to turn the unit on, the unit will then start scanning
for DAB channels immediately.
After the system reset, all the tuned stations, DAB and FM preset stations and
alarm settings will be erased.
Display Backlight
In mains power mode there are three backlight levels to choose from.
1. Press and hold the MENU/INFO button to enter the menu.
2. Press the
or button until “System” shows on the display.
3. Press SELECT to conrm.
4. Press the
or button until “Backlight” shows on the display.
5. Press SELECT to conrm.
6. Press the
or button to select “Low”, “Medium” or “High”.
7. Press SELECT to conrm.
There are no backlight settings in battery mode.
LHDR15_IB.indd 15 24/02/2016 08:30