To Next Page

To Previous Page

DAB Operation

Ensure that you fully extend the aerial vertically before switching the unit on. When the unit

is connected to the mains power and then switched on from standby for the rst time, or

you have just performed a factory reset the unit will automatically enter into the DAB mode

and perform auto scan function.

During the scan the display will show “Scanning ...”

together with a slide bar that indicates the progress

of the scan and the amount of stations that have been

found so far.

Once the scan has nished, the unit will select the rst

alphanumerically found station.

To scroll through the found stations, press the

or button and then press the

SELECT button to listen to the selected station.

DAB Auto Scan

The auto scan will search for the entire DAB Band III channels. After the scan has nished,

the rst alphanumerically found station will be automatically selected.

Full auto scan will not replace the DAB stations in memory it will add to it. If

you want to remove all the previous scanned stations, system reset or Prune is

required.

1. Press and hold the MENU/INFO button to enter the menu.

2. Press the

or button to select “Full scan”.

3. Press SELECT to conrm. The display will show “Scanning …” and a progressing

slide bar.

4. All the stations found will be stored automatically. To scroll through these stations, press

the

or button and then press the SELECT button to listen to the selected station.

Secondary Services

You may see a “<” symbol after the name of the station, this indicates that there are

secondary services available to that station. These secondary services contain extra

services that are related to the primary station. e.g. a sports station may want to add extra

commentaries. The secondary services are inserted directly after the primary station in the

station list.

To select the secondary station, press the SELECT button when the “<” appears in

the display before the station name. When the secondary service ends, the unit will

automatically switch back to the primary station.

LHDR15_IB.indd 16 24/02/2016 08:30

Logik LHDR15 User Manual

Questions and Answers: