To Next Page

To Previous Page

3. Fix the top plate.

Connecting the Induction Hob to the Mains Power Supply

1. Remove the 2 screws A and push the top plate

back and then lift it up.

2. Insert the mains cable at the connection.

The socket must be connected according to the relevant standard or connected to a single-pole cut-out. The

method of connection is shown below:

screw A

• The induction hob must be connected to the mains power only by a suitably qualified electrician.

Check with an electrician whether the domestic wiring system is suitable without alterations.

• Before connecting the hob to the mains power supply, check that:

1. The domestic wiring system is suitable for the power drawn by the hob.

2. The voltage corresponds to the value shown on the rating plate.

3. The mains cable sections can withstand the load specified on the rating plate.

• To connect the induction hob to the mains power supply, do not use adapters, reducers, or

branching devices, as they can cause overheating and fire.

• The mains cable must not touch any hot parts and must be positioned so that its temperature will

not exceed 75˚C at any point.

• Check with an electrician whether your domestic wiring system is suitable without alterations.

• Any alterations must only be made by a qualified electrician.

3 × 6 mm

/ 3 × 2.5mm

• This appliance must be

earthed.

• For these connections a

power lead of wire type

HO5V2V2-F should be used.

PELN

N1 L2 L1N2

• If the mains cable is damaged and needs to be replaced, the operation must be carried out the

by qualified person.

• If the induction hob is being connected directly to the mains an omnipolar circuit-breaker

must be installed with a minimum opening of 3mm between contacts.

• The installer must ensure that the correct electrical connection has been made and that it is

compliant with safety regulations.

• The mains cable must not be bent or compressed.

• The mains cable must be checked regularly and only replaced by a qualified person.

LINDHOB10_IB_final110415.indd 21 15/04/2011 2:16 PM

Logik LINDHOB10 User Manual

Questions and Answers: